![]() Setting the modem to answer on zero rings may not work. WINDOWS NT4 & 2000 - These products may have Remote Access Service (RAS) and Routing and RAS service set to answer on the first or second ring. You can always restore the Custom Defaults to Factory Defaultsīy issuing these 2 commands from HyperTerminal: AT&F AT&W YouĬan examine exactly what modem commands are being sent by TAPI-compliant apps by In most cases, apps that use your modem will send the AT&FĬommand before starting initialization to start from a known configuration. If the modem receives a new ATS0=# command, or if it receives AT&F (factoryĭefaults). The phone after the specified number of rings. Is not zero, when the modem is turned on, or reset, it will default to answering Issuing a Write command to the modem (usually AT&W). You (or some other software) must save a different configuration by Normally, the Custom Defaults (ATZ) are the same as Factoryĭefaults. Include an auto-answer 'ON' option that takes priority. Some modems (USR/Courier) have dip switches that All modems' factory defaultsĭisable auto-answer (ATS0=0). * - Most modems have 2 'default' configurations - Factoryĭefaults (AT&F) and Your Custom Saved Defaults. (You can put them back in after you check to see if this is a Page for screenshot), write down any existing entry and remove any extra Preventing the voice/fax software from accessing the modem.Ĭheck your modem's 'EXTRA SETTINGS' (see this No other software is running that has the modem port open The voice/fax software is installed, running, configured to use your modem, and Send initialization to make the modem answer in the desired mode (voice/fax). Software must give the modem a s0=# command if the modem is to answer, and also This test made the modem answer in data mode. ![]() Using the correct location in your DUNS connectoid. The country you are in, and, if you have more than 1 location, that you are Make sure that you have told Windows/ControlPanel/Telephony Installation: Detection of ring is based upon the country If it does not answer, it may not be installed correctly, or it mayīe defective. If your modem answered the call, it's auto-answer capability (With Modemchk, you have to sendĪnother AT command after the modem answers to see the modem's responses.) The report of RING and eventually NO CARRIER. Type: ATS0=1 (that's s-zero equals 1: tells the modem toįrom another phone, dial the line the modem is on. WithinĢ rings, the modem should answer with a tone. You can check the operation of your modem as follows:Īnd give the modem AT&F make sure it returns OK. Usually in the setup/options of the software that you want to use to answer theĬall. ![]() If the modem is not answering calls when you want it to, it's It, press CTRL+ALT+DEL after your system boots into Windows and examine the list Software may run automatically at start-up, so if you have difficulty locating Microsoft Fax, Any other Fax Program, Any Voice/Answering Machine software. ![]() Is in the setup of some of the software you have installed and configured toĪnswer the phone. If the modem is answering calls when you don't want it to, it Some data/fax/voice modemsĪlso have distinctive ring capabilities. Your modem to automatically answer the phone when it rings and act as anĪnswering machine, fax machine, and/or data modem. Depending upon your system and setup, you may or may not want
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |